Documentation › Opening models
Opening models
What Gusset opens, how to export from your CAD, and how to keep a study when the design changes.
Files it opens
| Kind | Formats | Notes |
|---|---|---|
| CAD | STEP, IGES, BREP | The best choice. Each solid body becomes a part, and the real CAD faces are there to click. |
| Mesh | STL, OBJ, PLY, OFF, 3MF, GLB | Repaired as they open. Faces are worked out from the shape, so a flat side or a cylinder is still one face to click. |
| Native CAD files | SolidWorks, Inventor, CATIA, NX, Creo, Parasolid… | Not opened. Export STEP from the CAD system. |
Exporting from CAD
- Export the assembly as STEP, as solid bodies. Tubes, plates and machined parts can be in one model, as they come. There is no need to make beams or mid-surfaces, or to remove small features.
- Parts that should be joined must touch. Faces of different parts closer than the gap tolerance (0.5 mm unless you change it under Solution settings) are joined. Parts that are further apart are not.
- Model the welds as nothing. Leave weld beads out of the CAD: Gusset lays the welds out itself where parts touch. See Joints.
- One body or many? An assembly exported as separate bodies lets you give parts their own materials and check their joints. A model exported as a single body solves with far fewer unknowns. Use one body when the joints are not what you are checking.
Mesh files
A mesh file carries no units. Gusset guesses them from the size of the model and asks you to confirm: millimetres, centimetres, metres or inches.
The mesh must enclose a volume. Gusset merges corners, removes bodies that were written twice and mends small holes and patches facing the wrong way. Anything it cannot close is left out, and you are told what was skipped.
How a model opens
Each time you open a model, Gusset asks how to start: Just open it, Guide me through it or Set it up for me (what each does). Tick Always do this to stop being asked. File › When a model is opened changes the choice later.
Saving a study
Save writes the study as a .fcs file: materials, joints, fixtures, loads and settings. The
study points at the model file and does not hold a copy of it, so keep the two together. If the model has
moved, Gusset looks for it beside the study.
When the design changes
You do not have to set the study up again when the CAD changes. Export the new version and choose File › Replace the model.
- Materials, print directions, part accuracy, joints you set by hand, fixtures, loads and settings are carried over.
- Each part is matched to the new part that lies where it lay, and each fixture and load to the face that looks the same way in the same place. So a wall made thicker or a hole moved keeps its setup.
- What could not be carried over, such as a face that is gone, is listed for you to put right.
If you only change the size or direction of a load, the next solve reuses the last solution and comes back in a fraction of the time.
Something wrong or missing on this page? Tell us.