Documentation › What Gusset does and does not do
What Gusset does and does not do
Gusset is a tool for an engineer's judgement and does not replace it. This page says plainly what it does and where it stops.
What it does
- Linear static analysis: stress, displacement and factor of safety under loads that do not change.
- Linear buckling: load factors and shapes.
- Natural frequencies: frequencies and shapes of the model as it is held.
- Joints: bonded faces, welds checked at the throat, and bolts, quick or with contact and preload.
- Layered materials: 3D prints, with plywood and carbon fibre sheet as experimental.
What “linear” means
The analysis assumes the material stays elastic and the deflections stay small. Within that, twice the load gives twice the stress. Outside it, the answer is no longer right:
- Stress above yield. The model does not yield. It reports the stress an elastic material would have, which tells you the part yields there and not how the load is shared afterwards.
- Large deflections. A cable, a thin membrane, or anything that moves by a good share of its own size changes shape as it loads, and a linear analysis does not follow that.
What it does not do
| Not modelled | What that means for you |
|---|---|
| Plasticity | No yielding, no collapse load, no residual stress. |
| Large deflections | No cables, snap-through or post-buckling behaviour. |
| Fatigue | A factor of safety against yield says nothing about a load that repeats. Use the stress ranges in a fatigue assessment of your own. |
| Loads that vary in time | No impact, shock, harmonic response or seismic analysis. |
| Heat | No thermal stress or temperature-dependent properties. |
| Contact between parts in general | Contact is solved in bolted joints only. Parts that merely rest on each other must be joined, or held with a fixture. |
| Sliding of bolted joints, bending of bolts | The slip check says whether friction holds; what happens after it lets go is not modelled. |
| Weld metal and heat-affected zones | Welds are checked at the throat against the parent metal. Residual stress and weld defects are not modelled. |
| Infill and plies | A print is solid with one stiffness; a sheet is one material through its thickness. |
The program
- Windows 10 and 11, 64-bit, only.
- It opens STEP, IGES, BREP and common mesh files. It does not open native CAD files.
- It cannot change the geometry. Changes are made in CAD, and Replace the model carries the study over.
How it has been checked
The accuracy page lists every case Gusset has been compared with, misses included, and links to the full verification document. Results on your own model are only as good as the materials, fixtures and loads you gave it. Anything safety-critical should be checked independently by a qualified engineer.
Something wrong or missing on this page? Tell us.