Gusset
All topics

Documentation › Buckling and natural frequencies

Buckling and natural frequencies

Two more answers from the same study: the load at which a slender structure buckles, and the frequencies it vibrates at.

Linear buckling

A slender column or frame can fail by buckling sideways at a stress far below yield. The stress plot does not show this. Buckling does.

  1. Open Settings on the Study tab and tick Linear buckling. Modes is how many buckling shapes to find; the first is the one that matters most.
  2. Solve.
  3. On the Results tab, open the arrow beside Modes and choose a buckling mode.

Each mode has a load factor and a shape. The factor multiplies all the applied loads, gravity included: a factor of 3.2 means the structure buckles in that shape at 3.2 times the loads you applied. A factor below 1 means it buckles before it reaches them.

The shape shows how it buckles, not how far: its size on screen means nothing. Animate it to see which members go.

Linear buckling assumes a perfectly straight, perfectly made structure. Real ones buckle earlier, so keep a margin. Factors of 3 or more are common practice.

Natural frequencies

Every structure has frequencies at which it rings. A motor, a pump or footfall near one of them shakes it far more than the size of the force suggests. Find them to keep a frame clear of the machine that sits on it.

  1. Open Settings and tick Natural frequencies. Frequencies is how many to find, from the lowest.
  2. Hold and load the model as for a static study, and solve.
  3. Open the arrow beside Modes and choose a vibration mode, such as “Vibration mode 1 (217 Hz)”. Animate it to see the shape swing either side of rest.

The report has a table of the frequencies and pictures of the first three shapes. The results also say how far the last pass moved each frequency. A coarse model reads high, so if they are still moving, solve a pass more.

What it does not do

  • The frequencies are those of the model as it is held. Change a fixture and they change.
  • The loads play no part. A member in tension is not stiffened by it.
  • Remote masses are not counted. For a motor on a frame, model the motor as a block of the right mass, or expect the real frequency to be lower than the one reported.
  • There is no damping, and no response to a force that varies in time: you get the frequencies and shapes, not how far the structure moves when shaken.
  • Single parts are checked against published benchmarks, on the accuracy page. An assembly of several parts has not been compared with a reference of its own.

Something wrong or missing on this page? Tell us.